Precision Switched Integrator Transimpedance Amplifier

Precision Switched Integrator Transimpedance Amplifier

This project is based on IVC102 chip from Texas Instruments. This chip is a precision integrating amplifier with FET OPAMP, integrating capacitors, and low leakage FET switches. It integrates low-level input current for a user-determined period, storing the resulting voltage on the...

Continue Reading
1.054
Views
0 Comments
Photo Diode Amplifier

Photo Diode Amplifier

This small module is a photodiode amplifier. The circuit consists of an OPAMP configured as a transimpedance amplifier for amplifying the light-dependent current of the photodiode. A small bias voltage is derived from the positive supply and applied to the op amp’s non-inverting...

Continue Reading
1.082
Views
0 Comments
Hi-Efficient 20W Mono Class-D Audio Amplifier

Hi-Efficient 20W Mono Class-D Audio Amplifier

This is a Hi-Efficient 20W mono Class-D audio amplifier, designed to drive speakers as low as 4 ohms in a bridge-tied-load configuration. Due to the low power dissipation and high efficiency of up to 90%, the module doesn’t require a heatsink. The project is built using PAM8320 chip...

Continue Reading
1.328
Views
0 Comments
4 Channel Current Sense Amplifier – Low and High-Side Voltage Output

4 Channel Current Sense Amplifier – Low and High-Side Voltage Output

This 4-Channel current sense amplifier is designed for cost-optimized applications. This is a current-sense amplifier (also called a current-shunt monitor) that senses the voltage drop across current-sense resistors at common-mode voltages from –0.2 V to +26 V, independent of the...

Continue Reading
1.155
Views
0 Comments
Ground Isolation Audio Amplifier for Automotive Applications

Ground Isolation Audio Amplifier for Automotive Applications

This Ground Isolation Amplifier is developed for car and automotive applications. The board efficiently eliminates problems caused by wiring resistance and removes noise generated by other electrical devices used in automobile environment. In a car or automotive the audio system is...

Continue Reading
1.175
Views
0 Comments
Precision Thermocouple Amplifiers with Cold Junction Compensation – Temperature Range −25°C to +400°C

Precision Thermocouple Amplifiers with Cold Junction Compensation – Temperature Range −25°C to +400°C

This Thermocouple Amplifier project provides a simple, low-cost solution for measuring thermocouple temperature. This board simplifies many of the difficulties of measuring thermocouples output. An integrated temperature sensor performs cold junction compensation. A fixed-gain...

Continue Reading
1.228
Views
0 Comments
Dual 2A Power Amplifier Module for TEC

Dual 2A Power Amplifier Module for TEC

This Dual 2A Power Amplifier module is a low-cost operational amplifier designed for driving a wide variety of loads while operating on low-voltage supplies. The dual amplifier can drive high output loads with a current of up to 2A. This Dual 2A Power Amplifier has been designed as a...

Continue Reading
1.156
Views
0 Comments
Mono 2W – Switch-Mode (Class D) Audio Power Amplifier

Mono 2W – Switch-Mode (Class D) Audio Power Amplifier

This is a compact size, mono, switch-mode (Class-D) audio power amplifier intended for multimedia and general-purpose high-power applications. It has greater than 87% efficiency and is capable of delivering 2W maximum continuous power to a 4Ω load. The project is designed to be...

Continue Reading
1.217
Views
0 Comments
Get new posts by email:
Get new posts by email:

Join 97,426 other subscribers

Archives