50V – 5A DC Brush Motor Driver – High Performance, High Reliability

50V – 5A DC Brush Motor Driver – High Performance, High Reliability

This is a powerful yet small-size and low-profile brushed DC motor drive system, with key features like adjustable constant current control, direction control, brake controls, Alert output, PWM for speed control, etc. The BD63150AFM chip is the heart of the project which is one...

Continue Reading
1.167
Views
0 Comments
DC Solid State Power Relay with Current Feedback

DC Solid State Power Relay with Current Feedback

Optically Coupled Power MOSFET Relay with Galvanically Isolated Current Monitor Output This project employs CPC1718J 100V Single-Pole, Normally Open DC-Only Power Relay and ACS71240 Galvanically Isolated Current Sensor IC with Common-Mode Field Rejection and Overcurrent Detection....

Continue Reading
1.317
Views
0 Comments
PWM Temperature Controlled FAN using TC648 and NTC sensor

PWM Temperature Controlled FAN using TC648 and NTC sensor

The project described here is a switch mode fan speed controller for use with brushed or brushless DC motors. Temperature proportional speed control is accomplished using pulse width modulation (PWM). 10K Ohms NTC is used to sense the temperature. The project is built using TC648 chip...

Continue Reading
2.041
Views
0 Comments
DC Motor Controller using Relay and MOSFET – Arduino Interface

DC Motor Controller using Relay and MOSFET – Arduino Interface

The project presented here is a low-cost solution to control high power brushed DC motor speed and direction. Traditional DC motor controllers are based on solid-state circuitry known as H-Bridge. Here we have made an H-bridge configuration using high current 2 x relays which can...

Continue Reading
1.868
Views
0 Comments
Low-Cost DC Motor Direction Controller with Fast Brake using 2 Relays

Low-Cost DC Motor Direction Controller with Fast Brake using 2 Relays

The project presented here is a low-cost easy to use DC brushed motor direction controller with fast-brake, the project was built using two 12V Relays, 2 x BJT transistors, and 2 x tactile switches. The two LEDs are provided to display the motor direction, 2 tactile switch controls...

Continue Reading
1.479
Views
0 Comments
8A Brushed DC Motor Driver with Adjustable Constant Current, Direction Control, Brake Control, Speed Control

8A Brushed DC Motor Driver with Adjustable Constant Current, Direction Control, Brake Control, Speed Control

This is a very powerful brushed DC motor drive system in a small package with a few key features like adjustable constant current control, direction control, brake controls, Alert output, PWM for speed control etc. The project was built using a TB67H303HG chip which is a full-bridge...

Continue Reading
1.453
Views
0 Comments
Bidirectional Speed Control for DC Motors

Bidirectional Speed Control for DC Motors

This is a very simple bidirectional speed control of a small DC brushed motor. The project is built using power OPAMP TCA0372 which can drive a load up to 1A. Connecting a small DC motor and trimmer pot will control the motor forward/reverse operation along with speed control. A...

Continue Reading
1.478
Views
3 Comments
DC Motor Speed, Direction and Brake Control with NRF24L01 RF Module – Arduino Compatible

DC Motor Speed, Direction and Brake Control with NRF24L01 RF Module – Arduino Compatible

This is Arduino compatible hardware that can control a single DC motor speed, direction, and brake using an RF remote control. The project is based on an ATMEGA328 microcontroller, H-Bridge DC motor driver chip LM18201, NRF24L01 RF module, 5V Regulator, 3.3V regulator and other...

Continue Reading
2.354
Views
1 Comments
Get new posts by email:
Get new posts by email:

Join 97,426 other subscribers

Archives